Comtech EF Data NetVue Release 1.1 Provisioning Guide - Manual (Page 12)

MN-NETVUEPVG or CD-NETVUEPVG Revision 1
NetVue Provisioning Guide Release 1.1
10
Figure 2 NPT Introduction Sheet
4. Three buttons permit navigation through the tool. The buttons are different on each page. Press Start to
begin the configuration sequence.
5. See Figure 3 Main Configuration Sheet.
6. Enter all the configuration data into the Main Configuration Sheet.
7. Set the number of rows to be displayed to equal the number of devices to be entered into NetVue.
8. After the number of rows is entered, press Enter and then Update Rows to increase or decrease the
number of configuration rows.
NOTE: Increase or decrease the numbers of rows as necessary, to make sure there is
space to enter devices or to prevent extra lines in the CSV file.
9. Enter the file name of the final CSV file into the blue field labeled Enter file name to be stored (no ext). Do
not add an extension to the file name. The .CSV extension is automatically generated. The resulting CSV
file is saved in the same directory where Excel was launched.
10. Enter each line of the network configuration:
• Status: Enabled/Disabled/Idle:
“Enabled” will create the device that previously did not existed in the NetVue
“Disabled” will remove the device that previously existed in the NetVue
“Idle” will create the device (if not previously existed in the NetVue) or change the
polling/monitoring status of the existing device in NetVue from Active to Idle