Contemporary Control Systems EISC Configurable Switches User Manual - Manual (Page 21)

TD021000-0MB
21
7.2.2
Setup Options
The Setup pull-down menu offers the options
shown in Figure 15:
Set the Individual Port Behaviors
Define How the Fault Relay Responds
Set Trunking, VLAN and Flow Control
Set the QoS Options
Lock in Your Settings
Restore All Default Settings
Set the Modbus Slave Address
Figure 15 — Setup Options
The first order of business is to configure the port parameters.
7.2.3
Setting Parameters for Twisted-Pair (RJ-45) Ports
When the “Port Parameters” option is chosen, the display shown in Figure 16 appears.
By default, each RJ45 port is set to auto-negotiate with full-duplex flow control. The
portion of Figure 16 outlined in red will be dimmed for models EISC12-100T/FC and
EISC12-100T/FT. Fiber ports are permanently set to 100 Mbps and full-duplex.
Figure 16 — Port Parameters
Figure 17 —
RJ45 Port Options
Each RJ-45 port has a pull-down menu so the port can be set
with any of the parameters shown in Figure 17. If either Half
Duplex option is chosen, the Full Duplex Flow Control check box
will be dimmed. In this case, half-duplex flow control will be set
by the Backpressure Flow Control option under Advanced
Features. Otherwise, full-duplex flow control may be engaged or
disengaged for each RJ-45 port on an individual basis.