Dish Network 104333 - Manual (Page 14)

AUX (Auxiliary) Mode for Tuner or Amplifier
14 104333
AUX M ODE B UTTON
To use the remote to operate a tuner or amplifier, you must first set up
the remote to control the device. See Controlling a Device on page 15.
Then, you must press the
AUX mode button to set the remote
to AUX mode. The AUX mode button’s back light turns ON to show
that the remote is set to AUX mode. Make sure to keep the remote
in AUX mode to use the buttons as described in this section.
M UTE B UTTON
Press this button to turn off the sound. Press it again to restore
the sound.
V OLUME B UTTON
Press the left-hand, minus (-) side of this button to lower the sound
volume. Press the right-hand, plus (+) side of this button to raise
the sound volume.
S ELECT B UTTON
This button works as the Input Select button for a tuner or amplifier.
U P /D OWN (A RROW ) B UTTONS
Use these buttons to change channels on the tuner or amplifier.
S TAR B UTTON
Use this button to set up the remote control in AUX mode.