CREATOR 8 inch touch screen CR-Wireless G7Cpip - Manual (Page 13)

CREATOR CHINA 2012-11 WWW. CREATOR1997.COM
7 Handheld Wireless Programmable Touch Screen User's Manual
the corresponding settings interface.
2,Finger across the appropriate option when
touching the touch screen, to get the focus. away
loses focus (and did not leave the touch screen),
leave touch-screen and enter the option of the
focus, if the focus is not in any option then will not
do any operation.
3, press the icon button at the right lower corner
to leave the setup program and return to the
Control Center.
2.2.3 RF
Click RF icon on the main page of the touch
screen to enter the RF setup interface. This page
is for wireless transmission settings.
RF settings interface of CR-Wireless G7C
CR-Wireless G8C touch screen, such as 2-7:
Figure 2-7
RF settings interface of CR-Wireless G7pip \
CR-Wireless G8pip touch screen, such as 2-8
below:
Figure 2-8
2, RFID refers to receiver ID which ranges from 1
to 16, the TPID is touch screen’s own ID,
corresponding
with PGMII, PGMIII host
engineering, its range is 1-50. Click the option to
modify the pop-up pulley (shown in Figure 2-9).
Figure 2-9
3,click the icon button at the right lower
corner to return to the main page.
4, on the RF interface of the CR-Wireless G7pip,
CR-Wireless G8pip touch screen, click on the
option will pop up pulley for corresponding
settings, as shown in Figure 2-10. Where:
Channel is used to set the transmitter
(CR-DS61, CRRFA-Ⅱ) video transmission
channels, currently only supports 7 different
channels (1-7);
Brightness option to adjust the video
brightness;
contrast option is used to adjust the video
contrast;
Saturation option is used to adjust the color
saturation;
The Hue option is used to adjust the colors
scheduling, and their values ​ ​ are 0-32.