Operating heater, Continued – Desa VRL30PT User Manual
Page 20
110021-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
20
Figure 33 - Pilot (Propane/LP)
Ignitor Electrode
Pilot Burner
Thermocouple
Figure 34 - Pilot (Natural)
Ignitor
Electrode
Pilot Burner
Thermocouple
Shutting Off Heater
1.
Turn control knob clockwise
to the OFF position.
2.
Turn rear burner control knob clockwise
to the
OFF position.
3a. Set selector switch in the OFF position.
3b.
If Using Optional Hand-Held Remote:
Set selector switch
in the OFF position to prevent draining battery.
Shutting Off Burners Only (pilot stays lit)
You may shut off the burners and keep the pilot lit by doing one
of the following:
1.
Turn control knob clockwise
to the PILOT position.
2.
Turn rear burner control knob clockwise
to the
OFF position.
3.
Use remote control manual OFF button.
4.
Set selector switch in the OFF position.
1.
Follow steps 1 through 6 under Lighting Instructions, page 20.
2.
Depress control knob and light pilot with match.
3.
Keep control knob pressed in for 30 seconds after lighting
pilot. After 30 seconds, release control knob. Now follow
steps 9 through 12, Lighting Instructions, column 1.
TO TURN OFF GAS TO APPLIANCE
MANUAL LIGHTING PROCEDURE
CAUTION: Do not try to adjust heating levels by
using the equipment shutoff valve.
7.
With control knob pressed in, press and release ignitor but-
ton. This will light pilot. The pilot is attached to the front
burner. If needed, keep pressing ignitor button until pilot lights.
Note:
If pilot does not stay lit, contact a qualified service
person or gas supplier for repairs. Until repairs are made,
light pilot with match. To light pilot with match, see Manual
Lighting Procedure.
8.
Keep control knob pressed in for 30 seconds after lighting
pilot. After 30 seconds, release control knob.
• If control knob does not pop out when released, contact
a qualified service person or gas supplier for repairs.
Note:
If pilot goes out, repeat steps 4 through 8.
9.
Slightly push in and turn control knob counterclockwise
to the ON position.
10. Wait one minute and switch selector switch to the ON posi-
tion to light burner.
Note:
AUTO is only functional when
using GWMT1 or GWMS2 optional accessories.
11. To light the front/rear burners, push in and turn rear burner
control knob counterclockwise
to the ON position.
WARNING: Make sure the selector switch is in the
OFF position when you are away from home for long
periods of time. Heater will come on automatically
with selector switch in the ON position.
OPERATING HEATER
Continued
O
F
F
PI
LOT O
N
AU
T
O
OFF
ON
Figure 32 - Control Knobs and Ignitor Button Locations (Shown
as Supplied, No Remote Control Operation)
Rear Burner
Control Knob
Selector
Switch
Ignitor Button
Control Knob
OPERATING HEATER (REMOTE-READY MODELS)
Lighting Instructions (Cont.)
To Turn Off Gas To Appliance
Manual Lighting Procedure