Daktronics MF-1000/1001/1002/1003/1004 - Manual (Page 12)

Daktronics part numbers are commonly found on drawings. Those part numbers can
be used when requesting replacement parts from Daktronics Customer Service. Take
note of the following part number formats. (Not all possible formats are listed here.)
• “0P- _ _ _ _- _ _ _ _” denotes an individual circuit board, such as a driver
board.
• “0A-_ _ _ _ - _ _ _ _” denotes an assembly, such as a circuit board and the
plate or bracket to which it is mounted. A collection of circuit boards
working as a single unit may also carry an assembly label.
• “W- _ _ _ _ ” denotes a wire or cable. Cables may also carry the assembly
numbering format in certain circumstances. This is especially true for
ribbon cables.
Most circuit boards and components within this display carry a label that lists the
part number of the unit. If a circuit board or assembly is not listed in the
Replacement Parts List in Section 4.5, use the label to order a replacement. A
typical label is shown in
Figure 2. The part number is in bold.
Figure 2: Typical Label
1-4 Introduction