Daktronics AF-3700-20 RGB - Manual (Page 28)

4.2 Signal Connections in Sectional Displays
After the sections are attached to each other and mounted to the
display structure, signal connections can be made.
Figure 28: Module Outputs
Connect the signal ribbon cables from the left modules of the
top section to the controller in the bottom left corner of the
bottom section. Refer to Figure 28 and Figure 30.
Connect the bonding jumper from the top section to the bottom
section by removing the outer nut, sliding the bonding jumper
loop onto the screw, and replacing the nut (Figure 29).
Figure 29: Bonding Jumper
Connection
Figure 30: Signal Connections in Sectional Display
Signal Installation 18