3 wireless ethernet bridge communication, Wireless ethernet bridge communication, Figure 31: wireless ethernet bridge layout – Daktronics AF-3700-20 RGB User Manual

Page 29

Advertising
background image

4.3 Wireless Ethernet Bridge Communication

If the communication system is a Wireless Ethernet Bridge, look for:

• a network card in the computer connecting to a network switch or router.
• a server radio mounted on the building and a client radio at the display.

Figure 31: Wireless Ethernet Bridge Layout

Connections
• Computer to network − RJ45 cable from computer port into network server in building.
• Network switch to DC injector.
• Wall power adapter from 120 VAC outlet to DC injector.
• Network cable from DC injector to server radio.
• Clear line of sight between server radio and client radio.
• Client radio to display − quick-connect cable to the middle jack on display back.


Troubleshooting

Component Check:

Cable

Connections

•

A cable connects the computer to the network.

•

A cable runs from the server to the DC injector.

•

A cable runs from DC injector to server radio.

•

The quick-connect cable is connected from the client radio to the middle jack

on back of display.

Diagnostic

LEDs

•

The green LEDs will be on when DC injector has power.

•

The server and client radios have internal LEDs. Refer to the Wireless

Ethernet manual for their specifications.

Display

Power

•

The display is either running a message or showing a single pixel flashing in

the bottom right corner of the display when power is on.

Software

•

The software and the display are set to the same network address.

•

Refer to the software manual for other possible conditions.

Signal Installation

19

Advertising