DFI COM330-B - Manual (Page 25)

25
2
Hardware Installation
Thermal Trigger
1
ON
4
5
1
ON
4
5
This jumper is used to simulate the signal status that indicates the Over Temper-
ature Signal (OVT) output from the Super I/O F71879. When monitored tempera-
ture exceeds the OVT value, OVT# will be asserted until the temperature goes
below the hysteresis temperature. Set J25 pins 1 and 2 to On to send THRM#
signal to the module.
J25
1-2 Off: Normal
(default)
1-2 On:
Thermal Trigger
1 2
1 2