DFI COM330-B - Manual (Page 28)

28
2
Hardware Installation
1
ON
4
5
1
ON
4
5
COM 3
COM 1
Serial (COM) Ports
COM 2
1
9
2
DCD-
TD
RD
DTR-
GND
RTS-
DSR-
CTS-
RI-
The system board is equipped with 3 onboard serial port (COM 1, COM2 and
COM 4). It is also equipped with a 9-pin connector for connecting an external se-
rial port (COM 3).
The serial ports are RS-232 asynchronous communication ports with 16C550A-
compatible UARTs that can be used with modems, serial printers, remote display
terminals, and other serial devices. To connect COM 3, please refer to the follow-
ing description. The serial port may be mounted on a card-edge bracket. Install
the card-edge bracket to an available slot at the rear of the system chassis then
insert the cable connector to the 9-pin connector. Make sure the colored stripe on
the ribbon cable is aligned with pin 1 of the connector.
COM 4