DFI CD101-N - Manual (Page 17)

www.dfi .com
17
Chapter 2 Hardware Installation
Chapter 2
Rear Panel I/O Ports
The rear panel I/O ports consist of the following:
• 1 4-pin 9-24V DC-in jack or 4-pin power connector (optional)
• 2 Serial COM ports
• 1 VGA port
• 1 DVI-I port (DVI-D signal)
• 4 USB 2.0/1.1 ports
• 2 LAN ports
• Mic-in jack
• Line-in jack
• Line-out jack
VGA
COM 1 USB 0-1
Line-out
Line-in
Mic-in
LAN 1
COM 2
DVI-I
(DVI-D signal)
LAN 2
DC-in
USB 2-3
Connect a DC power cord to this jack. Use a power adapter with 9~24V DC output voltage.
Using a voltage higher than the recommended one may fail to boot the system or cause dam-
age to the system board.
DC-in 9~24V
3: GND 4: GND
2: DC-IN 1: DC-IN