DFI DL631-C226 - Manual (Page 32)

www.dfi .com
32
Chapter 3 BIOS Setup
Chapter 3
ACPI Power Management Configuration
This section is used to configure the ACPI Power Management.
About Resume by PME
(PCI, PCIE, LAN).
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
ACPI Power Management Confi guration
Resume by PME
Resume by Ring
Resume by RTC Alarm
Wakeup Event After G3
Advanced
[Enabled]
[Disabled]
[Disabled]
[Enabled]
Resume by PME
Enables this field to use the PME signal to wake up the system.
Resume by Ring
Enables this field to use the Ring signal to wake up the system.
Resume by RTC Alarm
When Enabled, the system uses the RTC to generate a wakeup event.
Wakeup Event After G3
This field is used to enable or disable the specific wakeup event after G3. It needs to
switch the hardware jumper (for AC power on) to the proper setting.
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit
Trusted Computing
This section configures settings relevant to Trusted Computing innovations.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Confi guration
Security Device Support
Current Status Information
No Security Device Found
Advanced
[Disable]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
Enables or Disables
BIOS support for security
device. O.S will not show
Security Device. TCG
EFI protocol and INT1A
interface will not be
available.
Security Device Support
This field is used to enable or disable BIOS supporting for the security device. O.S will
not show the security device. TCG EFI protocol and INT1A interface will not be
available.