DFI HD636-H81CS - Manual (Page 41)

41
Chapter 3 BIOS Setup
Chapter 3
www.dfi .com
Network Stack
This section is used to enable or disable UEFI network stack.
Enable/Disable UEFI
network stack.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Network Stack
Advanced
[Disabled]
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Network Stack
Ipv4 PXE Support
Ipv6 PXE Support
Advanced
[Enabled]
[Enabled]
[Enabled]
Enable/Disable UEFI
network stack.


Enter:
+/-:
F1:
F2:
F3:
F4:
ESC:
Select Screen
Select Item
Select
Change Opt.
General Help
Previous Values
Optimized Defaults
Save & Reset
Exit


Enter:
+/-:
F1:
F2:
F3:
F4:
ESC:
Select Screen
Select Item
Select
Change Opt.
General Help
Previous Values
Optimized Defaults
Save & Reset
Exit
When Network Stack is enabled, it will display the following information:
Enable or Disable Serial
Port (COM)
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Serial Port 7 Confi guration
Serial Port
Device Settings
Change Settings
Advanced
[Enabled]
IO=248h; IRQ=5;
[Auto]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit
Serial Port
Enables or disables these serial ports (COM).
Change Settings
Selects the IO/IRQ settings for the super I/O device.