Regular maintenance checklist, Lubrication – DR Power Walk-behind 12.5 Premier User Manual

Page 15

Advertising
background image

CONTACT US AT www.DRpower.com 15

Chapter 4: Maintaining Your PREMIER DR FIELD and BRUSH MOWER

Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this manual and the
engine manufacturer's owner's manual for maintenance procedures. Service intervals listed in the checklist below supersede
those listed in the engine manufacturer's owner's manual.

Regular Maintenance Checklist

NOTE: Consider the service intervals shown as maximum under normal operating conditions. Increase frequencies under extremely dirty

or dusty conditions.

P

ROCEDURE

B

EFORE

E

ACH

U

SE

E

VERY

25

H

OURS

E

VERY

100

H

OURS

Check Operator Presence Switch

Check Engine Oil Level

Check General Equipment Condition

Check Blade for Sharpness

Clean Engine Exterior and Cooling Fins

Lubricate Wheel Clutch Lever*

Clean around Idlers

Check Tire Pressure

Change Engine Oil

1

st

time 5 hours

Check all Belt Tensions and Condition

Check Cable connections

Replace Air Filter and Pre-cleaner

Replace Spark Plug

Replace Fuel Filter

* SAE 30 Oil; NEVER use penetrating oil.

Lubrication

Your PREMIER DR FIELD and BRUSH MOWER was lubricated at the Factory.
The Spindle and Transaxle are lubricated for life and sealed at the factory. The
operator needs to periodically lubricate the Wheel Clutch Cable and provide
engine lubrication.

Supplies Needed:

SAE 30 Oil

1. Lubricate the Wheel Clutch Cable with SAE 30 Oil (Figure 7). Apply the lubricant into the cable housing while working the

cable back and forth a few times. You should do this at both ends of the cables. Perform this lubrication more often in dry
and dusty environments.

Shut down the engine, remove the spark plug wire and wait 5 minutes before
performing any maintenance procedure or inspection on the Mower.

Wheel Clutch
Cable

Figure 7

Lubricate

Lubricate

Shut down the engine, remove the spark plug wire and wait 5 minutes before performing any maintenance procedure or
inspection on the Mower.

Advertising