DR Power Tow-Behind Yard Trimmer - Manual (Page 19)

CONTACT US AT www.DRpower.com 19
Replacing the Tracking Wheel
Tools Needed:

Pliers
1. Remove the Cotter Pin with Pliers and remove the Tracking Wheel Assembly
(Figure 37).
2. Install the new Tracking Wheel Assembly with the Valve Stem facing out.
3. Secure with the Cotter Pin.
Replacing the Tracking Wheel
Tools Needed:

Pliers
1. Remove the Cotter Pin with Pliers and remove the Caster Wheel Assembly
(Figure 38).
2. Install the new Wheel Assembly.
3. Secure with the Cotter Pin.
Check the Tire Pressure (Tracking Wheel)
Tools Needed:

Tire Pressure Gauge

Air Compressor
1. Remove the Valve Stem Protective Cap (Figure 39) and check the tire
pressure with a Tire Pressure Gauge.
2. Check what the manufacturers recommended pressure is that is stamped
on the side of the Tire.
3. If the pressure reading is too low, add air through the Valve Stem with an air
hose.
4. Replace the Valve Stem Protective Cap when finished.
Tracking
Wheel
Figure 37
Cotter Pin
Valve
Stem
Caster Wheel
Figure 38
Caster Wheel
Caster Wheel
Figure 39
Valve Stem
Do not over inflate the tires. Inflate to the manufacturers recommended
pressure found on the tires.