DR Power Tow-Behind Yard Trimmer - Manual (Page 9)

CONTACT US AT www.DRpower.com 9
Do not over inflate the tires. Inflate to the manufacturers recommended
pressure found on the tires.
9. Insert the Caster Yoke pivot into the Caster Bracket and secure with a 5/8"
Washer and Cotter Pin using Pliers (Figure 9).
10. Install the Chain Link into the inside hole of the Caster Bracket and place the
end of the Spring into the Link (Figure 10). Close the Link to secure the
Spring.
Greasing the machine before use
Tools and supplies needed:

Grease Gun with General Purpose Grease
1. Apply three to four pumps of Grease to the Pivot Shaft Grease Fitting (Figure
11).
2. Apply three to four pumps of Grease to the Tracking Wheel Grease Fitting
(Figure 12).
Check the Tire Pressure
Tools Needed:
 Tire Pressure Gauge

Air Compressor
1. Remove the Valve Stem Protective Cap (Figure 13) and check the tire
pressure with a Tire Pressure Gauge.
2. Check what the manufacturers recommended pressure is that is stamped on
the side of the Tire.
3. If the pressure is too low, add air through the Valve Stem with an air hose.
4. Replace the Valve Stem Protective Cap when finished.
Cotter Pin
Figure 9
Caster Yoke
Caster Bracket
Washer
Valve Stem
Protective Cap
Figure 13
Spring
Figure 10
Chain Link
Pivot Shaft
Figure 11
Grease Fitting
Wheel Hub
Figure 12
Grease Fitting