ESI GigaStation - Manual (Page 24)

23
specific port fader to adjust the level individually. To adjust a stereo level, move the
mouse over the middle of the stereo ports. The selected port fader will turn into a
brighter color to indicate the selected ports. You can move the fader in three different
ways:
-Drag the fader as you press the left mouse button.
-Select the fader with the mouse cursor and adjust with the mouse wheel. You can
select the steps from the pull-down menu. ‘Config’ -> ‘Mouse Wheel.’
-Select the fader with the mouse cursor and use the up and down arrows of your
keyboard.
2. Level Meter
The Level Meter will display incoming signal levels. This will be active when there is
a signal coming from the CD Input.
3. Input Level Indicator
The Level Indicator shows the current level set for the CD Input.
2. Analog Outputs 1~8
This is the output volume control fader that controls outputs 1~8 of the GIGAStation.
All 8 level faders act the same so you need to learn only one. The 4 Stereo outputs of
the GIGAStation PCI card are connected with OUT 1,2 OUT 3,4 OUT 5,6 and
OUT 7,8 of the Control Panel.
1. Level Fader
The Level Fader will change the level of the wave out volume. You can control
outputs 1~8 individually or control the stereo pairs like outputs 1-2, 3-4, 5-6, and 7-8.
You need to move the mouse pointer over the specific port fader to adjust it
individually or move the mouse pointer over the middle of the two ports to adjust it in
stereo. If the port fader(s) is selected, it will turn into a brighter color.
You can move the fader in three different ways. Basically, the volume level can be
adjusted by ±0.5dB.
- Drag the fader as you press the left mouse button.
- Select the fader with the mouse cursor and adjust with the mouse wheel. You can
select the steps from the pull-down menu, ‘Config’ ->’Mouse Wheel.’