ETA Silentino - Manual (Page 23)

– Avoid contact with the rotating brush when handling the vacuum cleaner (e.g. with loose
clothes, hair, fingers, jewellery, bracelets etc.).
– Do not leave the floor nozzle with the rotation brush on in one place for too long! It could
cause damage to the surface vacuumed!
– Never use the vacuum cleaner with wet hands or feet!
– When you vacuum a staircase, never leave the vacuum cleaner higher than you stand yourself!
– Never leave the product unattended when in operation!
– Never immerse the vacuum cleaner into water (even its parts)!
– Never vacuum without a properly inserted filtration system and micro-filters.
– When the appliance is overheated, the automatic heat fuse is activated and it disconnects
power supply. If it happens, switch off the appliance and unplug it from power supply. Then
remove possible visible obstacles preventing air flow and let the appliance cool down.
– Before you start using the vacuum cleaner, please check that all the locking mechanisms
are in the right position.
– Do not use the brush for treatment and cleaning animal hairs!
– Do not vacuum wet or moist floor coverings, do not use the vacuum cleaner for outdoor
areas! When moisture gets into the aggregate, there is a risk of its damage and disabling it.
This defect is not covered by the warranty.
– Vacuum cleaning of some carpet types may result in generating static electricity.
No static electricity discharge is dangerous to health.
– When handling, do not pull the hose applying excessive force and avoid rough handling
of the vacuum cleaner!
– The appliance must not be used in damp or wet environment and in any environment with
the danger of fire or explosion (spaces where chemicals, fuels, oils, gases, paints and
other flammable or volatile materials are stored).
– Do not vacuum sharp objects (e.g. glass, shatter), hot, flammable, explosive items
(e.g. ash, hot cigarette butts, gasoline, thinners and aerosol vapours) or greases
(e.g. fats, oils), caustic agents (e.g. acids, solvents). Vacuuming these objects may lead
to damage of the dust filters or the vacuum cleaner.
– Do not put fingers or other things to input and output vents of the appliance. If the vents/elements
for air flow are clogged (e.g. the hose), turn the appliance off and remove the clogging.
– The vacuum cleaner is not suitable for vacuuming substances that can harm human health.
– Pores of the dust filter may be clogged when vacuum cleaning very fine dust. Thus, air
permeability will be reduced and the suction performance will decrease. In this case the
dust filter must be changed and clean micro–filters, even if the dust filter is not full yet.
Do not use the vacuum cleaner to vacuum dirt produced during/after construction such
as plasterboard dust, fine sand, cement, dust from construction, parts of plaster etc.
If this dirt / loose construction materials / loose construction materials into the aggregate,
it poses a danger of damage. The warranty repair does not cover this.
– Never leave the vacuum cleaner exposed to weather conditions ( rain, frost, direct sun
radiation, etc.).
– It is not permissible to adjust the surface of the extra attachment (e.g. self–adhesive
paper, foils, etc.)!
– The power cord is marked with colour codes. The yellow strip indicates the ideal cord
length, the red strip indicates the maximum cord length. Do not apply force to unwind the
cord beyond the red mark.
– Do not run over the power supply cord when using the vacuum cleaner and do not unplug
it from the socket by pulling the power cord.
23
GB
/ 45