ETA Silentino - Manual (Page 25)

III. VACUUM CLEANER PREPARATION
Hose (Fig. 5)
– Connect hose C2 to the vacuum cleaner by inserting the end piece to suction vent A1
to the maximum position and turn to the right. You will hear a clicking sound.
– To disassemble proceed in the reverse sequence.
Telescopic tube (Fig. 2, 4)
– You can connect tube C3 with hose handle C9 by slight pushing the handle to the tube.
– You can disconnect the tube by pulling the handle slightly out of the tube.
– The telescopic tube allows setting suitable length to fit your figure. Slide the relevant part
of the tube out or in. When pulling out, keep the tube in safe distance from your face as the
tube is very long.
Floor nozzle / parquet nozzle / turbo brush
– Connect and disconnect the accessories ( C1, C7, C8) in the same way as the tube (Fig. 3).
Floor / crevice nozzle / brush
– Connect and disconnect the accessories ( C4, C5, C6,) in the same way as the tube.
You can connect the appliance directly to the hose handle or to the telescopic tube (Fig. 3).
IV. USE OF VACUUM CLEANER
Remove all packing material, take out the vacuum cleaner and the accessories. Pull out
necessary length of power cord A10 and plug the power cord into a socket (Fig. 10).
Assemble the vacuum cleaner accessories C1, C2, C3 (Fig. 2, 3, 4, 5). If the cleaner is
fitted with telescopic tube C3, adjust its length to fit your figure (Fig. 4). Floor nozzle C1 is
designed to be used to clean carpets or smooth flooring (Fig. 6). If the floor nozzle is fitted
with a brush, pull it out by switching over a flap when vacuuming hard floorings. You can use
crevice nozzle C6 for vacuuming places that are hard to access (Fig. 7). Upholstery nozzle
C4 or brush C5 can be used to clean various types of furniture (Fig. 8, 9). Floor nozzle C7 is
intended for vacuuming smooth floors. The TURBO brush C8 can be used to clean carpets
with low hair and smooth floors (not suitable for carpets with thicker hair). The vacuum
cleaner can be switched on or off by pushing button A4 marked with the symbol (Fig.
11). You may adjust the suction power with the A6 and A7 buttons (pic. 12). The minimum
suction power is recommended for fine fabrics (e.g. curtains, drapes). The maximum suction
power is recommended for floor coverings (e.g. heavy-duty carpets). After finishing work,
switch off the vacuum cleaner and unplug it from the power supply. By switching button A5
with symbol the power cord will be wound automatically. The vacuum cleaner can be
held and carried by handle A9.
Turn on and off:
The vacuum cleaner must first turn on by the button ( A4) on the vacuum cleaner.
Maximum suction power will be set on the vacuum cleaner when switched on. Pressing
( A4), the vacuum cleaner is switched off completely.
25
GB
/ 45