FiberPlex VIS-4832 - Manual (Page 9)

7
Getting Started
Setting up and using your Light Viper 4832 is a quick and simple process. Just follow these steps:
1. Place the VIS‐4832 in a rack with your digital mic‐pre’s or other source. Place the VIM‐1832 Mixer Box close to the mixer so that
the send cables can reach the console’s inputs. connect AC power.
2. Connect and run the Fiber between the two boxes, power up and check the Sync light on both units
3. Connect the inputs and returns to the stage box.
4. Connect the analog fan out or digital cables to the console or recording device.
5. If remote controlling Yamaha AD8HR or Aphex mic‐pre’s via a Yamaha console, at the console end connect the DGL‐422 from the
Yamaha 9 pin control connector to the VIM‐1832 RJ45 “control” connector. At the stage end, connect the DGL‐422 cable from the
RJ45 “control” connector on the VIS‐4832 to the 9 pin remote control connector on the AD8HR mic pre’s.
6. Start mixing.
NOTE: the signal output of the VIS‐4832 on the analog outputs is line level. When connecting this system into
a console or other device, use line level inputs or engage input pads to achieve optimal signal‐to‐noise ratio.
The more advanced functions of the Light Viper VIS‐4832 (control, clocks, etc.) are addressed later in this
manual.