FiberPlex TD-1580 - Manual (Page 11)

Inserting a Module
1) Attach an ESD‐preventative
wrist or ankle strap, following its
instructions for use.
2) Disconnect and remove all
interface cables from SFP
Module.
3) If the SFP Module has a Bail
Clasp , close the Bail Clasp
before inserting the SFP
Module.
4) With the gold finger connector on the bottom and the label on the top, line up the SFP Module
with the empty cage and slide it in making sure that it is completely inserted and seated in the
cage.
Removing a Module
1) Attach an ESD‐preventative
wrist or ankle strap, following
its instructions for use.
2) Disconnect and remove all interface
cables from SFP Module.
3) Release the latching mechanism.

Bail Clasp – Open the bail clasp on the SFP
Module with your finger in a downward
direction.

Actuator Button – Gently press the
actuator up (or in) while pulling the
body of the SFP Module to release the
SFP Module from the cage.

Mylar Tab – Pull the tab gently in a
straight outward motion until it
disengages from the port. Make sure
the tab is not twisted when pulling as it may become disconnected from the SFP
Module.

Slide Tab ‐ With your thumb, push the slide tab on the
bottom front of the SFP module in the direction of the
equipment to disengage the module from the line card
port. If you pull on the SFP module without disengaging
the tab, you can damage the SFP module.
4) Grasp the SFP Module between your thumb and index
finger and carefully remove it from the port
5) Place the SFP Module on an antistatic mat, or
immediately place it in a static shielding bag or container
Actuator Button