FiberPlex TIS-8632 - Manual (Page 9)

Page 7
Tray Mounting
Complementing the flexibility of the FiberPlex ‘TD Series’ of fiber optic modules, the TDR‐01‐AC provides
mounting, power and cable management for up to 6 modules in a compact and rugged aluminum 1U rack. The
integrated key‐hole mounting holes on the bottom the TD units lock securely on mating studs while a rear
retention bar holds them securely in place. A 6 position wiring harness and included power adapter provide,
not just 9 VDC power, but a positive earth ground to the modules via 3 position Phoenix™ locking power
connectors. Managing all that cabling and fiber can sometimes be quite a chore so an extended cabling tray
with integrated tie down points are provided to help make your installation clean.
**NOTE: The TDR and TDP trays use a 9VDC 3.5 Amp power adapter. When 3 TIS‐8632 are used in the same
rack certain SFP populations could exceed a 3.5 Amp requirement. Please carefully check your configuration
against the specification table to verify your current draw.
Figure 5 TIS‐8632 installation on a TDR‐01‐AC tray