FiberPlex TDP - Manual (Page 6)

Features
Figure 1 TDP
TDP Mounting Tray – The base tray of the TDP is made from rugged anodized aluminum and features
reinforced rack ears. This 1U tray has 6 pairs of studs pressed into the base to mate with the keyholes on
TD‐Series modules.
FiberPlex TD‐Series Modules – Shown here for clarification, however, they are not included. The TDP
can accommodate up to 6 TD‐Series modules.
Retention Bar & Retention Screws – Once the TD‐Series modules are securely seated on the
pressed studs, the Retention Bar slides in behind them to secure the modules tightly in place.
Two Retention Screws are then tightened to hold the bar.
Cable Tie Down – Seven tie‐wrap bases are found along the raised rear panel of the Mounting Tray.
These are provided to allow for clean management of cabling to the TD‐Series modules. Tie‐wraps can
be used to secure cable bundles against the rear panel. The left rear corner of the Mounting Tray features a
cut out to allow cable egress.
Back Shell Relief – The unique design of the bar provides clearance notches for Back Shell Relief in the
event that Phoenix™ back shells are to be installed on the wiring harness or individual power
connections. These relief cuts also make inserting the power connections easier while the Retention Bar is in
place.
1
2
3 4
6
5