Fire Magic Custom Gourmet Unibody Series 12 & 13 - Manual (Page 10)

10
FLAVOR
GRIDS
FLAVOR GRID
LEG
BURNER
OFF
HI LIGHT
LOW
5. INSTALL THE FLAVOR GRIDS
Place the flavor grids directly on the burners. Make sure the
legs (see Figure 10) of the flavor grids rest on the burners.
Center the grids over the burners with the open side up. This
allows heat from the burners to be evenly distributed throughout
the cooking area. Fire Magic Flavor Grids are stainless steel
and will heat and cool quickly, making your barbecue very
responsive to the changes you specify in grill temperature.
They are rust resistant and may be cleaned with standard oven
cleaners.
ADJUSTING YOUR CUSTOM GOURMET BARBECUE cont'd
FOR AUTOMATIC LIGHTING:
1. Open the lid.
2. Turn all barbecue gas valves and the backburner valve to
the 'OFF' position.
3. Turn on the gas at the
source outside of the
barbecue enclosure.
4. Remove the
backburner cover if you are
lighting the backburner.
NOTE: DO NOT turn on
more than one valve at a
time for either automatic or
manual lighting. Adjacent
barbecue burners will
cross-ignite.
5. Depress either one of the gas valve knobs or the Backburner
knob and turn to 'HIGH' then immediately press the spark
generator button (see Figure 13). The burners should light.
CAUTION: If the burners do not light within 5 seconds depress
the knob and turn the valve to 'OFF'. WAIT 5 MINUTES before
repeating step 5. If the burners still do not light after several
attempts, refer to the instructions for manual lighting.
LIGHTING INSTRUCTIONS
FOR MANUAL LIGHTING:
CAUTION: Always wait 5 minutes for gas to clear after
any unsuccessful lighting attempt.
1. Follow steps 1 through 4 of "Automatic Lighting" section
2. Insert either a burning long-barrel butane lighter, a burning
long-stem match or a burning match held by a wire
extension holder (Figure 12) through the cooking grids to
the burners below the flavor grid (Figure 12). For
backburners, hold the flame against the perforated material
near the backburner.
3. While holding the match or lighter flame next to the burner,
depress the appropriate valve knob and turn it
counterclockwise to the 'HIGH' position. The burner should
light.
4. If the burner does not light, IMMEDIATELY DEPRESS the
knob and turn the valve to 'OFF'. WAIT 5 MINUTES before
repeating steps 2 through 4 of the 'Manual Lighting'
instructions.
NOTE: Barbecues in some installations achieve a better air/
gas mixture and will ignite quicker if the valve is first
turned beyond High to Medium or Low for lighting.
REMEMBER: FOR SAFE MANUAL LIGHTING, PLACE A
BURNING MATCH OR BUTANE LIGHTER BESIDE THE
BURNER - THEN TURN ON THE GAS (Figure 13).
Read entire instructions before lighting.
Follow the instructions each time you light your Fire Magic Barbecue or Backburner.
Figure 12 - Match Holder
IF YOU SMELL GAS
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If the odor continues, immediately call your gas
supplier or fire department.
Figure 13 - Knob Positions &
Manual Lighting
OFF
HI
LIGHT
LOW
TO
TU
RN
OFF
TO
TU
RN
O
N
READ SETTING
HERE
HIGH TO
LIGHT
Figure 11 - Valve Control
Knob
Figure 10