Fire Magic 2D-SSA Beverage Center - Manual (Page 10)

REV 6 - 1402170710 L-C2-274 10
CHANGING THE BULBS (IF EQUIPPED)
Important: ONLY REPLACE WITH 12V / 10 WATT
HALOGEN BULB(S).
WARNING: To protect from potentially sharp sheet metal
and glass, wear gloves and safety glasses
during this procedure.
1. Turn off all electrical sources.
Important: Place one hand directly below the glass lens
and prepare to catch it when it is detached.
2. Carefully insert your fi ngernail or a thin plastic spatula
between the glass lens and the stainless steel, and
gently pry the glass lens out (Fig. 10-1). Catch the lens
(Fig. 10-2) and set it safely aside.
Note: You may wish to take this opportunity to clean and
dry the lens with a standard household window
cleaner. Dry completely before reattaching.
3. Wearing a pair of gloves, reach into the fi xture, gently
grab the bulb (Fig. 10-3), and pull it straight down and
out of the fi xture so that the two pins at the base of
the bulb come all the way out.
Important: Bulb is halogen. DO NOT TOUCH with bare
hands. Oils from hands drastically reduce
bulb life.
Note: It may be helpful to rock the bulb gently backward
and forward while pulling it out.
4. Insert the new 12V / 10 watt halogen bulb into the
socket so that both pins slide all the way into the two
holes in the bottom of the socket.
5. Place the lens back into the fi xture opening with the
curved cut-out toward the back and snap it back into
place.
BEVERAGE CENTER COVER
To reduce the need for cleaning, cover your beverage center
between uses with the Fire-Magic
® custom cover (Fig. 10-4).
Always remove items from the upper storage area before
covering.
Uncover the beverage center with care. Always lift or slide
the cover gently off the upper storage rack. Never pull
sideways, as the rack may be damaged or loosened.
CLEANING & MAINTENANCE
Fig. 10-1 Pry glass lens out
Fig. 10-2 Catch lens and set aside
Fig. 10-3 Remove bulb
Fig. 10-4 Beverage center cover