Fire Magic 2D-SSA Beverage Center - Manual (Page 6)

REV 6 - 1402170710 L-C2-274 6
ASSEMBLY (cont.)
drawer. Locate the blender cord through the opening on the
right above the receptacle (Fig. 6-1) and plug it in.
Ensure the blender rests in the tray in front of the domed lid.
See blender instructions for additional details on blender
installation, use, and maintenance. Test the blender and
electrical connection by applying and turning off power
without the container in place.
PLACE THE CUTTING BOARD
Unpack the wood cutting board and place the four (4) rubber
feet into the four (4) depressions on top of the counter in
front of the sink (Fig. 6-2). The cutting board is designed to
stay fi rmly in place while in use and yet be easy to remove,
clean, and store as needed.
PLACE STAINLESS-STEEL BOTTLE/FOOD
HOLDERS (STAND ALONE ONLY) AND
CONDIMENT STORAGE CONTAINERS (BUILT-IN
AND STAND ALONE)
Unpack the stainless-steel bottle/food holders and condiment
storage containers with lids.
Place the condiment storage containers in the rectangular
holes in the top of the counter in front of the blender. Cover
them with the rectangular lids (Fig. 6-3).
On the stand alone only, lift the left shelf and lock it into
place following the instructions below, then insert the two
stainless-steel bottle holders into the circular holes in the
top of the shelf (see Fig. 6-4).
Alternately, a tap for draught beverages could be installed/
inserted through the rear circular hole.
Cutting board
Stainless-steel
counter
Drawer slider
Inner wall
Outer wall
Receptacle
WARNING
Do not use blender in rain or
wet conditions.
Fig. 6-1 Plug-in blender inside left stand alone wall
Fig. 6-2 Match cutting board feet to holes
Fig. 6-3 Slide the containers into countertop
Fig. 6-4 Slide the holders into the shelf-top holes