Flowserve LNGT - Manual (Page 45)

LNGT USER INSTRUCTIONS ENGLISH 00083107 02-08
Page 45 of 48
®
8.4 General Arrangement Drawing
The typical general arrangement drawing and any specific drawings required by the contract will be sent to the
Purchaser separately unless the contract specifically calls for these to be included into the User Instructions. If
required, copies of other drawings sent separately to the Purchaser should be obtained from the Purchaser and
retained with these User Instructions.
9 CERTIFICATION
Certificates determined from the Contract requirements are provided with these instructions where applicable.
Examples are certificates for CE marking, ATEX marking etc. If required, copies of other certificates sent
separately to the Purchaser should be obtained from the Purchaser for retention with these User Instructions.
10 OTHER RELEVANT DOCUMENTATION AND MANUALS
10.1 Supplementary User Instructions
Supplementary instructions such as for a driver, instrumentation, controller, seals, sealant system etc are
provided as separate documents in their original format. If further copies of these are required they should be
obtained from the supplier for retention with these User Instructions.
10.2 Change notes
If any changes, agreed with Flowserve Pump Division, are made to the product after its supply, a record of the details
should be maintained with these User Instructions.
10.3 Additional sources of information
Reference 1:
NPSH for Rotordynamic Pumps: a reference guide, Europump Guide No. 1, Europump & World Pumps,
Elsevier Science, United Kingdom, 1999.
Reference 2:
Pumping Manual, 9
th
edition, T.C. Dickenson,
Elsevier Advanced Technology, United Kingdom, 1995.
Reference 3:
Pump Handbook, 2
nd
edition, Igor J. Karassik et al, McGraw-Hill Inc., New York, 1993.
Reference 4:
ANSI/HI 1.1-1.5, Centrifugal Pumps - Nomenclature, Definitions, Application and Operation.
Reference 5:
ANSI B31.3 - Process Piping.