Flowserve 2564 Mixerpac - Manual (Page 5)

5
Mixerpac 2564 - Installation and Maintenance Instruction for Machinery Parts
tion, however, must be observed to prevent malfunctions that in
turn could directly or indirectly give rise to serious injury and / or
property damage.
2.2 The customer and / or the operator must ensure that all persons assigned to handle,
assemble or operate the machine have carefully read these installation and maintenance
instructions, before they commence any installation and maintenance work at the
MIXERPAC or before operate the machine. These personnel must be fully acquainted
with the layout and function of the MIXERPAC and the respective support system.
2.3
Damage may cause leakage in liquid or gaseous form. The hazardous effects cor-
respond to those of the product, and there may be hazard to persons or the envi-
ronment. The operator’s regulations concerning work safety, accident prevention,
and pollution for this plant section must be adhered to without exception.
2.4
!
Components coming into contact with the leakage must be corrosion-resistant or
corrosion-proof.
2.5
If the application of the MIXERPAC requirements is subject to the ATEX 94/9/EC,
then it is also imperative to comply with the annex for the assembly and mainte-
nance instructions of the ATEX 94/9/EC guidelines.
2.6
!
MIXERPACs must be decontaminated before they are sent to FLOWSERVE for
maintenance or repair.
2.7
!
When employing elastomers of EP (ethylene-propylene) or butyl rubber, do not
use any grease or oil on a mineral basis as a barrier or quench fluid.
2.8
A loss, a re-establishment or a change of the power supply for the machine and
/ or the barrier system may not impair the properties of the MIXERPAC and / or
involves a risk of personal injury and / or considerable damage to property.
2.9
Assigned protection devices from the machine manufacturer must be accordingly
arranged and may no cause additional endangerments. They must ensure the
necessary range for the accessibility to maintenance work to the MIXERPAC.
2.10
The electrical supply of the machine must correspond to the protection targets
of the Directive 2006/95/EC.
No endangerments for persons and environment may proceed from a non elec-
tric power supply.
3.0 General
3.1 All illustrations and details in these operating instructions are subject to technical
alterations that are necessary in improving the MIXERPAC.