Flowserve Swing Check Valves 2.5-24 - Manual (Page 17)

Swing Check Valves FCD ADENIM0013-00
16
5.0 DISASSEMBLY
(Continued)
5.1.2.2 Configuration (Fig. 14)
In this configuration, the disc assembly is attached to the bonnet and will come out of the
body along with it. Once free of the body, the bonnet can be laid down with disc assembly
upmost. To remove the disc/hinge assembly, loosen the staked-setscrew(220) that holds the
hinge pin (041) in the hinge support bracket (007). With the disc/hinge assembly properly
supported the pin can be withdrawn.
(NOTE: The hinge support bracket mounting position on the bonnet is critical. Removal of the
bracket should not be attempted unless the bracket is damaged beyond further use. If
replacement of the bracket is required, an Anchor/Darling Field Service Engineer should be
contacted for assistance.)
FIGURE 14