Flowserve 103 Smart Multi-Port IPS Wireless - Manual (Page 10)

IPS WIRELESS SELD-103 ENGLISH 26999976 11-13
Page 10 of 20
flowserve.com
5. The battery pack should be visible on the lower
end of the transmitter assembly. Carefully
disconnect the battery pack connector.
Remove the nuts holding the battery bracket in
place and remove the bracket. Remove the
battery pack.
Figure 6: SELD-103 unit battery with external
housing removed
Figure 7: SELD-103 unit with battery bracket
removed and battery pack partially removed
6. Install new battery pack (part number S1-
1043). Reinstall battery bracket and nuts,
reconnect battery pack connector.
7. Install tube back onto unit and tighten set
screw to no more than 0.9 Nm (8 lb.-in US).
8. Reinstall SELD-103 unit in the field.
9. Reconnect sensor cable(s).
10. Install magnetic set screw into the base of the
unit.
11. Install any applicable accessories on the
SELD-103 unit.
12. Dispose of battery pack in accordance with
instructions in section 2.5 Disposal Instructions.
5 CUSTOM CONFIGURATION
PROGRAMMING
This section is optional. As long as your
specific application was communicated to the
factory prior to shipment, the SELD-103 unit is pre-
configured for your specific use.
Errors in programming
configuration can render the SELD-103 unit
inoperable, proceed with caution. Flowserve is
not liable for any damage caused by user
configuration errors.
For instructions on how to change software
configuration options on the SELD-103 unit, refer to
the PSP software user instructions. The list below
provides an overview of the functions that can be
performed using this software utility:
- Reading & saving SELD-103 configuration
- View & modify SELD-103 transmission
intervals
- Setting the time on the SELD-103
- Calibration of individual sensors on SELD-
103 unit
- Read live data from sensors on the SELD-
103 unit
- Turn specific SELD-103 sensor channels
on or off
For instructions on how to perform software options
on the VB-103-TAM unit, refer to the IPS Dock user
instructions. The list below provides an overview of
the functions that can be performed using the IPS
Dock and appropriate software utility:
- Reading & saving VB-103-TAM log data
- Clearing the log from the VB-103-TAM
- Setting the time on the VB-103-TAM
- Changing the data logging interval on the
VB-103-TAM
6 INSTALLATION
Always wear appropriate personal
protective equipment during the installation of
SELD-103 units.
6.1 Tools required

Allen Wrenches (1/8” and 3/16”)

Tools required to install the various
mounting configurations are conditional
based on the type of mounting and location

Phillips head torque screw driver
Nuts holding
battery bracket
Battery bracket
Battery wires