Q-See QSD6204 - Manual (Page 40)

Chapter 6. USB Programming (optional)
6. USB Programming
6.1 Install
1. Place the USB Driver Program CD into your CD ROM.
2. If your CD ROM does not auto-run the install CD, go to “My Computer”, select
your CD drive, and click on “PCVIEWER.EXE”.
3. Follow the prompts on your PC to finish the installation.
6.2 Program Interface
To run the program (Double click “ ” icon on your desktop).
System will detect the HDD automatically when you connect the USB cable to
your PC.
Note: If the HDD is not detected, please perform the following steps:
(1)
Close the USB program window, and remove the USB cable.
(2)
Press [ PLAY] twice to put the DVR into the Playback mode.
(3)
Connect the USB cable to the PC again.
Please allow up to 30 seconds for the DVR to show video on your PC.
Please make sure that the PC has detected the hard drive before you double click
player icon.
-37-