Fluke Biomedical 960SF-220 - Manual (Page 19)

Appendix
Connector Designations
A
A-3
960SF Jumpers (Including 960AJ)
Designation Position Purpose Factory Setting
W2 N 4-20 mA OFFSET 960SF-220/221/230/231
W3 N 4-20 mA OFFSET 960SF-220/221/230/231
W5 A-B For – HV 960SF -230/231
B-C For + HV 960SF-220/221
W6 A-B For + HV 960SF-220/221
B-C For – HV 960SF-230/231
W7 N 4-20 mA 960SF-220/221/230/231
W8 N
To digitize 300:1 HV on
Flow input 2
-
OUT To digitize Flow 2 960SF-220/221/230/231
W10 A-B D1 enable sig. on PRAM 960SF-220/221/230/231
B-C +5 V to enable RAM -
W11 A-B +5 V to enable RAM -
B-C D0 enable signal 960SF-220/221/230/231
W9 A-B
Positive input signal from
detector. (GM)
As required
B-C
Negative input signal from
detectors (Scintillation)
As required
J5 Conductor B
Positive input from
detectors (GM)
As required
Conductor A
Negative input from
detectors (Scintillators)
As required
W12 A-B
Presence for Flow input or
analog output.
960SF-220/230
B-C
Indicates no Flow input or
analog output.
960SF-221/231
W13 - Not Used
W14 - Not Used
960AJ Jumpers
Designation Position Purpose Factory Setting
W1 A-B
Use with 857/897 GM
detectors
As required
W1 B-C
Use with 843 Scintillation
detectors
As required
W2 N Disables Anti-Jam Factory test
W2 OUT Enables Anti-Jam Normal
W3 N Protects Fuse Factory test
W3 OUT
Will allow fuse to blow if
Anti-Jam occurs
Normal