Formax FD 6102 - Manual (Page 29)

28
7.5 Envelope and Insert Specifications
Remarks:
• Maximum insert specifications are based on single sheets. When multiples are
handled, more room inside the envelope is needed depending on the application.
• The specification of the paper handling equipment is often wider than that of the
envelopes and documents handled. The condition of material handled will limit the
specified environmental conditions.
• We recommend that materials to be handled are stored at a temperature of 20°C
(68°F) with a relative humidity factor of 50%. If difference in temperature occurs
between store room and mailing area, the material has to be stored near the system
at least 24 hours before use.
• Self-copying paper may cause rubber parts to wear quicker. The rubber used in this
system has the best resistance to Wiggins Teape material.
Enclosure quality BRE, minimum: 18.75# bond
BRE, maximum: 30# bond
Insert, minimum: 18.75# bond
Insert, maximum: 62.5# bond
Envelope quality Minimum: 18.75# bond
Maximum: 30# bond
A B C D E F G
Minimum size mm 229 105 32 10 142 90*
70 g/m 2
inches 9.0 4.1 1.25 0.40 5.6 3.5
Maximum size mm 241 162 54 35 A-12** B-6 1.5
inches 9.5 6.4 2.1 1.4 A-0.47** B-0.24 0.06
* In case of fold only (no insert): height > 120 mm / 4.7
** When insert is more than 1 mm (0.04 inch): A-15 mm / A-0.6 inch