Formax FD 8850CC - Manual (Page 5)

english english
12 Powerline 450.2 03/2011
Pa per jam
You have fed in too much paper.
Paper shredder jammed.
Red LED in the key pad f ashes.
Paper shredder reverses automati-
cally.
Notice! Do not press dashed arrow button and
green arrow button alternately for-
wards and backwards.
Cutting unit can be damaged.
CAUTION!
Injuries by cutting rollers are possible
even when the paper shredder is idle.
Keep hands away from the cutting
system!
• Open the f ap and clear the paper
jam.
If material is not completely pushed
out, then
• Close the f ap again.
• Press dashed arrow button.
Paper is pushed out.
• Pull paper out.
• Separate paper stack and feed paper
again.
• The shredding process is started
again with the green arrow button or
by the light barrier (paper feed).
Electric motor overheated
Red LED on membrane keyboard
lights.
Paper shredder switches off auto-
matically.
• Allow paper shredder to cool down
for approx. 15 to 20 min.
Front door or fl ap opened
Red LED on membrane keyboard
lights.
Paper shredder stops automatically.
• Close door and f ap.
Note If the door is opened when the cut-
ting device is running, the document
shredder must be started again using
the green button after the door of the
document shredder has been closed.
Bag for shredded material full
Red LED on membrane keyboard
lights.
Paper shredder stops automatically.
Note Reversing the cutting device (“Re-
verse” button) is also possible even
when the shredded material container
is full.
• Insert new bag.
Notice! Empty the shredded material con-
tainer after the paper shredder has
been switched off, because otherwise
malfunctions of the cutting system
could occur when the rocker switch is
pressed several times in succession.
5 Troubleshooting