Formax FD 4170 - Manual (Page 18)

14
The optional Output Conveyor can be installed in the paper outfeed of the FD 4170.
The conveyor can be operated independently by following these steps:
OPTIONAL CONVEYOR OPERATION
■
Option
Optional conveyer unit can be installed in the paper ejection part on the V-417.
Please contact our service person concerning the optional conveyer unit.
z
Conveyer Unit
The conveyer unit can handle large amount of
processing.
Already burst paper can be taken out freely with
this unit even while the machine is in process of
bursting.
■
Option Independent Operation
This is operation mode that an optional conveyer unit independently operates when the optional
conveyer unit is installed on the machine.
1. Turn the power on to make the machine “stand-by” status.
2. The machine starts operating by holding down the STOP/C key and the JOG key
simultaneously.
LCD operation
3. Independent operation mode completes by releasing the JOG key.
29
1. Turn on power to place burster in Stand-by mode.
2. Start operation by holding down the STOP/C button
and JOG button simultaneously.
■
Option
Optional conveyer unit can be installed in the paper ejection part on the V-417.
Please contact our service person concerning the optional conveyer unit.
z
Conveyer Unit
The conveyer unit can handle large amount of
processing.
Already burst paper can be taken out freely with
this unit even while the machine is in process of
bursting.
■
Option Independent Operation
This is operation mode that an optional conveyer unit independently operates when the optional
conveyer unit is installed on the machine.
1. Turn the power on to make the machine “stand-by” status.
2. The machine starts operating by holding down the STOP/C key and the JOG key
simultaneously.
LCD operation
3. Independent operation mode completes by releasing the JOG key.
29
3. Independent operation mode finishes by releasing the
JOG button.
TROUBLE-SHOOTING
TROUBLE REMEDY
Power will not turn on, even after pressing “I” side of
power switch
Check that power cable is properly connected to the
machine and an appropriate wall outlet
Machine does not operate or stops even after
pressing the START button
Check the LCD display for an error message. Refer
to Error Displays (on following pages), then complete
the action required.