Formax V-STACK36 - Manual (Page 5)

3
1. Determine location of folder or pressure sealer
and where the stacker will sit.
2. Remove the extended outfeed tray from the folder
or pressure sealer.
3. Align the outfeed of the folder or pressure sealer
with the infeed of the stacker.
4. Place the 6-roller-ball deck onto the pins (A) on
either side of the stacker infeed and slide into
place.
5. Place the crossbar (B) of the guide wheels into the
grooves of the stacker infeed.
6. Plug power cord into stacker and appropriate elec-
trical outlet. Swtich on power. (C)
7. Adjust the vertical paper stop (see pg. 4).
8. Load documents or forms into the input machine
and operate as usual. The forms will feed from the
folder/pressure sealer into the stacker.
9. When the stacker is nearing full capacity, the red
LED (E) will light. At this time, stop the folder/pres-
sure sealer, press the run-out button (F) to clear
the infeed, and remove the finished documents.
NOTE: the horizontal paper stop is spring-loaded.
Set-up and operation
1. Attach stacker to mounting plate on stand see as-
sembly instructions on pg. 5.
2. Adjust the height of the stand/stacker using the
lock handle.
3. Continue setup following the procedure above.
Without V-Stack36-10 Stand
Guide Wheels
Crossbar
6-ball-roller deck
B A
With V-Stack36-10 Stand
C
Vertical paper stop
D
E
F
Lock handle
Mounting plate