Foxconn Destroyer - Manual (Page 105)

98
5
2. Select a RAID array for use (also can refer to section 5-3)
After rebooting your computer, you will see the RAID software prompting you to
press [F10].
Press [F10] to enter the NVIDIA MediaShield BIOS setup and configure the mirrored
RAID array as described in the 5-3 section. Finally, you can reach this step as
depicted.
3. Press [Ctrl]+[X] keys to exit and go to Windows.
4. In Windows, click "Cancel" to skip any "Found New Hardware Wizard".
Use driver CD and click on "Chipset Driver" to install the NVIDIA RAID driver. The
RAID driver can be installed only when you select and enable "RAID" in BIOS "SATA
Operation Mode" setting. If you do not select RAID, then RAID driver can not be
installed.
MediaShield BIOS Mar 31 2008
- Array List -
[Ctrl-X] Exit [↑↓] Select [B] Set Bootable [N] New Array [ENTER] Detail
Boot Status Vendor Array Size
Healthy NVIDIA MIRROR 232.88G