Foxconn Destroyer - Manual (Page 28)

21
2
2-7 Onboard Button
Power on Button: POWER_ON
Push the power on button to power on the system.
Reset Button: RESET
Push the reset button to reboot the system.
Clear CMOS Button: CLR_CMOS1
Turn off the AC power supply, push the CLR_CMOS1
button and hold there for a couple of seconds to clear
CMOS.
2-8 Onboard LED
DRAM Power LED: (Red)
The LED lights up indicating the system is on or the
system is staying at S1 or S3 sleeping state.
+5V Standby LED: (Blue)
It will light whenever the power supply that connected
to the motherboard is switched on.
■
Make sure the power supply is turned off before pressing the CLR_CMOS1 button to
clear CMOS.
■ Push down the CLR_CMOS1 button and hold it there for a couple of seconds to clear
the CMOS completely, then release.
C
A
U
T
IO
N
!
Do not remove or plug in any device when the onboard LED is lighting on.
W
AR
NING!
POWER_ON RESET CLR_CMOS1