Foxconn Destroyer - Manual (Page 25)

18
2
2-5 Install the Optional Accessory
Install Heat-Pipe Expansion Module
1. Find the chipset heatsink, take off the removable piece in its groove.
2. Find the Heat-Pipe expansion module, remove the protected film from its surface.
3. Place the Heat-pipe onto the heatsink, and fasten four screws to fix it.
Install Quantum Flow-GPU Blower
This 120mm fan can provide good cooling for the graphics card, especially in multi-GPU setups.
You can easily use the accompanied screws to fix it on the graphics card, then attach the 3-wire
fan connector to the fan header on the motherboard.
PCB Tray
If you choose not to use the chassis, you can
use the plastic tray and copper bars to assemble
the motherboard in an open environment as
depicted.
Note: The PCB or plastic tray (in the package) is
assembled under the motherboard.
Screw
Screw
Screw