Denon DVP-602CI - Manual (Page 21)


Getting Started
Connections
Setup
Playback
Information
Troubleshooting
Specifi
cations
Network Setup
Make network settings.
F Menu tree F
Setup
Network Setup
a Network Setup
s Power Saving
d Network Information
e Use the ui p button to input the address and press the ENTER
button.
IP Address :
Set the IP address within the ranges shown below. The Network
function cannot be used if other IP addresses are set.
CLASS A: 10.0.0.0 ~ 10.255.255.255
CLASS B: 172.16.0.0 ~ 172.31.255.255
CLASS C: 192.168.0.0 ~ 192.168.255.255
Subnet Mask :
When connecting an xDSL modem or terminal adapter directly
to the DVP-602CI, input the subnet mask indicated in the
documentation supplied by your provider. Normally input
255.255.255.0.
Default Gateway :
When connected to a gateway (router), input its IP address.
Primary DNS Secondary DNS :
If there is only one DNS address indicated in the documentation
supplied by your provider, input it at “Primary DNS”. If there are
two or more DNS addresses, input the fi rst one at “Secondary
DNS”.
r Use the i button to select “Exit” and press the ENTER button.
Setup is complete.
b When connecting to the network via a Proxy server, select “Proxy”
and press the
ENTER button (vpage 19 “Proxy settings”).
a Network Setup
Wired LAN settings
Use this procedure to confi gure the Wired LAN settings.
1
Connect the LAN cable (vpage 13).
2 Turn on the DVP-602CI (vpage 24).
DVP-602CI performs automatic network setup due to the DHCP
function.
When connecting to a network that has no DHCP function,
perform the setting in Operation 3.
3
Set the IP address at the GUI menu “Setup” –
“Network Setup” – “Network Setup”.
q Select “Detail” and press the ENTER button .
w Use the o p button to set “DHCP” to “OFF”, then press the i
button.
The DHCP function is disabled.
• If you are using a broadband router (DHCP function), there is no need
to make the settings at “Setting the IP Address” and “Setting the
Proxy”, since the DHCP function is set to “ON” in the DVP-602CI’s
default settings.
• If the DVP-602CI is being used connected to a network without the
DHCP function, the network settings must be made. In this case,
some knowledge of networks is required. For details, consult a
network administrator.
• If you cannot connect to the Internet, recheck the connections and
settings (vpage 13).
• If you do not understand about Internet connection, contact your ISP
(Internet Service Provider) or the store from which you purchased
your computer.
q Select “Detail”.
• DHCP (Dynamic Host Confi guration Protocol) :
These are systems by which the IP address and other network
settings are automatically set for the DVP-602CI, computer,
broadband router and network devices.
• DNS (Domain Name System) :
This is a system for converting the domain names used when
browsing Internet sites (for example, “www.denon.jp”) into the
IP addresses actually used for communications (for example,
“202.221.192.106”).
e Input the address.
r Select “Exit”.
w Set “OFF”.
DVP602CI_ENG_6th.indd 18 2008/03/26 16:37:36