Full duplex aggregated application, Datacom systems inc – Datacom Systems SS series SPAN User Manual

Page 22

Advertising
background image

Datacom Systems Inc

SPAN and Multi-Link Aggregators/Regenerators • USERguide

22

2. Connect network cables to the VERSAstream

™

NETWORK duplex-LC ports. The

LED associated with each duplex-LC jack is solid green indicating when light
signal has been detected on the respective Rx NETWORK port.

3. Connect analysis devices to the VERSAstream

™

MONITOR ports. Two DRL494–2m

cables are provided to connect analysis SC ports to the MONITOR duplex-LC ports.
Either, the MONITOR duplex-LC Link LED or the MONITOR RJ45 Link LED is solid
green when link has been established between the respective monitor port and analy-
sis device. The LED is flashing green when data is passed from the respective moni-
tor port to the analysis device.

Full Duplex aggregated Application —

shown in Figure 14,

focuses on monitoring and analyzis of the full duplex aggregated input into one single
stream of data using a FIBERtap

™

in conjunction with the VS-1022SX-SX. This VS-

1022SX-SX is similiar to other VERSAstream

™

SPAN series installations:

To connect the VERSAstream

™

VS-1022SX-SX SPAN Series aggregator/regenerator,

refer to Figure 14 and follow these steps:

Figure 14 - VS-1022SX-SX Hardware Installation

1. Two power supplies are provided. Use of the second power supply is strongly

recommended to assure uninterrupted monitoring. Connect both power supply
barrel connectors into the power 1 and 2 ports, respectively, of the VERSA-
stream

™

. Plug the power supplies into the external power source, furthermore,

Advertising
This manual is related to the following products: