Datacom Systems SS series SPAN - Manual (Page 24)

Datacom Systems Inc
SPAN and Multi-Link Aggregators/Regenerators • USERguide
24
To connect the VERSAstream ™ VS-1022BT-BT SPAN Series aggregator/regenerator,
refer to Figure 15 and follow these steps:
1. Two power supplies are provided. Use of the second power supply is strongly
recommended to assure uninterrupted monitoring. Connect both power supply
barrel connectors into the power 1 and 2 ports, respectively, of the VERSA-
stream
™ . Plug the power supplies into the external power source, furthermore,
connecting the second power supply to a different external power source circuit
than the first power supply eliminates power as a single point of failure. The
POWER 1 and 2 LEDs illuminate indicating power 1 and 2, respectively, are on.
Either LED not illuminated indicates a defective power source and immediate
replacement is required to insure redundant power integrity.
2. Connect network cables to the VERSAstream ™ RJ45 NETWORK ports. The NETWORK
RJ45 left integrated LED is solid green indicating link has been established on
the port. The LED Display Code table deciphers the RJ45 jacks with integrated
LEDs that display line status and line speed of each port.
3. Connect analysis devices to the VERSAstream ™ RJ45 MONITOR ports. The MONITOR
RJ45 left integrated LED is solid green indicating link has been established on
the port. The LED Display Code table deciphers the RJ45 jacks with integrated
LEDs that display line status and line speed of each port.
1,000 Mbs
100 Mbs
10 Mbs
Green
Orange
OFF
LED Display Code
Link
Data
Code Left LED
Solid Green
Flashing Green
Code
WITH LINK OR DATA
Right LED