Gladiator GAWUXXPTTG Project Caddy - Manual (Page 2)

2
INSTALLATION INSTRUCTIONS
Project Caddy Use Requirements
■ Intended to be installed on Gladiator ® Garageworks GearWall ®
panel or a GearTrack ® channel.
■ Maximum weight limit is 25 lbs (11.34 kg) for each hook.
■ Maximum weight limit is 100 lbs (45.36 kg) for the project caddy.
Unpack the Project Caddy Parts
Remove the project caddy parts and fasteners, and dispose of/
recycle all packaging materials.
Assemble Project Caddy
Gather the required tools before starting assembly.
Tools Needed:
1. Place the left-hand side piece on a flat surface. Insert the tool
bag hook into the lower channel in the side, as shown.
2. Insert the support rod into the upper channel in the side, as
shown.
3. Insert the tool bag hook and the support rod into the channels in
the right-hand side piece, as shown. Rotate the tool bag hook
downward over the support rod until it locks into place.
4. Insert the threaded studs at the top of each side piece into the
two holes in each side of the project caddy back.
5. Using two acorn nuts (F10) per side, attach the sides to the back.
Completely tighten with a
³⁄₈" nut driver.
6. Attach the project caddy shelf (with the name badge facing up)
by interlocking the shelf tabs with the tabs on the project caddy
back.
NOTE: The tabs on the project caddy back fit underneath the
tabs on the shelf.
F3b F10
F3b Phillips-head screw (2) F10 Acorn nut (10)
■
³⁄₈" Nut driver
■ Phillips screwdriver
A. Left-hand side
B. Tool bag hook
C. Support rod
A
B
C
A. Right-hand side
A. Project caddy back
B. Acorn nuts (F10)
A. Project caddy shelf
A
B
A
A
A