Grip Factory Munich GF-16 - Manual (Page 18)

GF-16 Crane System Instruction Manual
Page: 17
Version 6
Front extension arms required 3 x 200 cm / 6' 6” + 1 x 100 cm / 3’ 3”
Rear extension arm required 1 x 192 cm / 6' 3”
Lift range 1205 cm / 39’ 6”
Maximum Euro-adapter height 816 cm / 26' 9”
Lift capacity (working load) 2 pers. + accessories 250 kg / 550 lbs
Counterweight required for max. load 1078 kg / 2371 lbs
Counterweight required to balance empty arm 266 kg / 585 lbs
Crane weight (excluding dolly and weights) 806 kg / 1777 lbs
Dolly weight (unit weights see page 46) 244 kg / 536 lbs
Arm reach (pivot to camera head mount) 829 cm / 27’ 2”
Length of rear end (pivot to outside of bucket) 278 cm / 9’ 1”
Continue from § 12, page 6
13. Connect the 200cm / 6’ 6” extension number 2 to extension number 1. Slip the
connection flanges into each other and secure with the provided safety pin.
Note: Section 2 must be supported by a suitable support stand or rostrum.
Tip: To avoid the sections jamming or getting stuck make sure that the sections
are joined parallel. Using a small amount of lubricant also helps. We suggest
rubbing the joints with an oiled rag prior to assembly.
14. Connect the 200cm / 6’ 6” extension number 3 to extension number 2. Slip the
connection flanges into each other and secure with the provided safety pin.
Note: Move the support stand or rostrum to support section 3.
15. Connect the 100cm / 3’ 3” extension to extension number 3. Slip the connection
flanges into each other and secure with the provided safety pin.
16. Connect a 200cm / 6’ 6” parallelogram rod to the parallelogram connection on the
middle section and secure it with the provided safety pin.
17. In turn, connect 2 x 200cm / 6’ 6” parallelogram rods to the first parallelogram
connection and secure them with the provided safety pins.
Note: Support the second parallelogram rod with the parallelogram support and
secure with the locking pin.
18. Connect the 100cm / 3’ 3” parallelogram rod to the last parallelogram connection and
secure it with the provided safety pin.
19. Connect the angle adjuster to the end of the 100cm / 3’ 3” extension. Release the
angle adjuster by removing the safety pins from the side of the angle adjuster. Secure
the angle adjuster to the 100cm / 3’ 3” extension with a removed safety pin.
Tip:
The angle adjuster has two sidewise safety pins. These are either used for
the angle adjusters transport position or to secure the connections between
angle adjuster and extension as well as angle adjuster and platform.
20. Connect the 100cm / 3’ 3” parallelogram rod to the rod on the angle adjuster and
secure it with the provided safety pin.
Tip:
The angle adjuster has an integrated leveller. By turning it, the vertical plate
on the angle adjuster can be set to a perfect right angle. Correct setting of
the angle adjuster enhances the crane’s balance.