Harken 7413.10 MKIV Jib Reefing & Furling built after Feb. 2009 - Manual (Page 16)

Assembly Top Foil
Place halves of plastic bushings on stay so
hooked part of longer section faces out.
Tip: With foil screw holes up as shown
below, place longer half of bushing
with hook on upper half.
Install trim cap. Place each side over wire.
Push trim cap into foil to start; tap
in using hammer.
Install trim cap screws.
16 MKIV units 3, 4
Red Loctite ®
adhesive.
Halyard deflector.
Unit 3 only.
Loctite is a registered trademark of Henkel
AG & Company KGaA.