Highgear Enduro Compass - Manual (Page 5)

7
english
8
english
REPLACING THE WATCH BATTERY
The Enduro watches use a common CR2032 3v Lithium battery. Normal battery life is
approximately 1yr.
NOTE: Heavy usage of the Compass or Backlight system may significantly
reduce battery life.
NOTE: A blank display or inaccurate compass readings are indications that the
battery is getting weak and should be replaced.
1. Remove battery door using a coin.
2. Carefully remove the old battery. Do not damage the O-ring
seal.
3. Place a fresh battery in the battery compartment with the
positive (+) side facing up.
4. Replace battery door using a coin.
5. If the O-ring has been damaged, replace it before reinstalling
the battery door. Most jewelers and watch shops should
have replacement O-ring seals.
NOTE: Extreme care should be taken when replacing the battery to ensure the
unit remains fully water resistant. Failure to properly replace the battery and
correctly seal the unit may cause the unit to become damaged and may void the
warranty
RESETTING THE WATCH
To reset the watch back to its default values PRESS the
MODE , SET/CLEAR , START/LAP and STOP/NEXT keys
down at the same time. The display will light up showing all
segments followed by a sequence of screens showing various
numbers. The watch will then automatically change to the time
of day screen at 12 o’clock on the first of January.
Resetting the watch will clear any information stored in the
watch. This should be done only as a last resort.
-! $%
( ). !
s

%4 %2 3 !4% 2 %3 )3 4! .4 (2 /. / ' 2 ! 0 (