HiTi CS-200e - Manual (Page 21)

19
4.1.2 Control panel warning messages
PMessages Displayed Description Solutions
Flipper Cover Open
IC Chip Missing
Ribbon Missing
Ribbon Mismatch
Ribbon Type Error
Ribbon Out
Print Fail
Card Out
Card Jam
Cam Error
Flipper Error
Ribbon Chip IC Error
Cover Open
Flipper cover door is opened
Ribbon IC chip is not inserted
Ribbon is not installed
Installed ribbon does not match with ribbon IC
chip ID
Unsupported ribbon type
Failing to searching ribbon
Fail to start printing process
Card runs out
Jammed during operation
Internal mechanical cam platen error
Flipper unable to perform its duty
Ribbon’s IC chip error
Top cover door is opened
Close the flipper cover door.
Install ribbon IC chip into printer’s IC chip socket.
Install ribbon with corresponded IC chip into printer.
Check ribbon type and install the corresponded IC chip.
Check ribbon’s region code with matching printer’s
region code.
Reinstall the ribbon again with correct installation procedure.
Check the ribbon to see if it’s snapped.
Place more cards with card’s weight module.
End of ribbon usage
Inconsistency between card thickness adjustor and card used
Reinstall a new ribbon with IC chip.
Get the setting of adjustor and card used consistent
Adsorption force among cards Move cards apart and then arrange them to input hopper for retry
Follow the LCM screen for releasing card jam instructions.
Contact your local service center for professional advice.
Contact your local service center for professional advice.
Reinsert IC chip again or change a new IC chip if it’s required.
Close the top cover door.
English
HiTi CS-200e & CS-220e user manual