DoorKing PC Compatible Multi-Door Access Controller 1838 - Manual (Page 29)

3.3.5 Touch-tone / Rotary-dial
This programming sequence will set the remote call station to dial out in either a touch-tone or rotary
format. Generally, this will be set for touch-tone.
Factory setting = touch-tone.
NOTE: This programming step is only used when a DKS Remote Call Station is connected to
the 1838 system.
1. Press * 0 7 and enter the four digit MASTER CODE _ _ _ _ (beep).
2. Enter 0 * (beep) for touch-tone or enter 1 * (beep) for rotary.
3. Press 0 # TOGETHER to end this programming step (beeeeeep).
3.3.6 Rotary-dial 9
This programming sequence sets which relay(s) will activate when the system receives a rotary-dial 9
open command from a rotary telephone. The system can be programmed so that only one relay will
activate, or any combination of relays will activate. To cause a relay to activate, enter a 1 in it's
respective character slot, or enter a 0 to not activate the relay. Any combination of 1's or 0's is
permissible. For example, entering 010 in step 3 will cause only relay 1 to activate. Entering 011 will
cause both relay 1 and relay 2 to activate.
Factory setting = 010.
NOTE: Although you are setting the rotary dial 9 activation for two relays only, you must enter
a three-digit code in step 2. Always use 0 as the first digit.
1. Press * 5 1 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the three-digit (1's or 0's only) rotary 9 code _ _ _ then press * (beep).
3. Press 0 # TOGETHER to end this programming step (beeeeeep).
1838-065-L-3-10 Page 29