DoorKing PC Compatible Multi-Door Access Controller 1838 - Manual (Page 31)

3.4.3 Programming Area Code
Program an area code when 10-digit or long distance calling is required. The area code will be
entered as a four-digit number (1 + the three digit area code) for long distance dialing. If an area
code is being programmed to facilitate 10-digit calling requirements, precede the three-digit area code
with #.
1. Press * 2 4 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter 1 then press * (beep).
3. Enter the four digit area code _ _ _ _ then press * (beep). NOTE-1: for long distance
calling requirements, enter 1 and the three-digit area code. NOTE-2: for 10-digit
calling requirements, enter # and the three-digit area code.
4. Press 0 # TOGETHER to end this programming step (beeeeeep).
3.4.4 Programming Phone Numbers with Area Code
In this section, phone number is referenced to the area code that was programmed in 3.4.3.
NOTE: If long distance or 10-digit dialing is not required, program the seven digit telephone
numbers as described in 3.4.2.
1. Press * 4 1 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.5.1) then press * (beep).
3. Enter 1 then press * (beep).
4. Enter the seven-digit phone number _ _ _ _ _ _ _ then press * (beep). If the number
that you are entering in this step is less than seven-digits, enter # in the empty
spaces. See 3.4.2, step 3.
5. Press 0 # TOGETHER to end this programming step (beeeeeep).
1838-065-L-3-10 Page 31