Hypertherm Powermax190c Operator Manual - Manual (Page 32)

OPERATION
1
powermax
190c Operator Manual 4-3
Operation
1. Install Torch Consumables
Note: Hand-tighten only
WARNING – INSTANT-ON TORCHES
PLASMA ARC CAN CAUSE INJURY AND BURNS
Plasma arc comes on immediately when the torch switch is activated. The plasma arc will
quickly cut through gloves and skin. Make sure power is off before changing consumables.
2. Attach the Work Clamp
1. Attach the work clamp securely to
the workpiece.
2. Attach the work clamp as close as
possible to the area being cut to
reduce exposure to electric and
magnetic fields (EMF).
3. Do not attach it to the portion of the
workpiece that will fall away.
Shield
120884
Cap
120898
Nozzle
120882
Electrode
120881
Swirl Ring
120880
PAC105 Torch
Shielded Consumables (for easier dragging or template cutting)
Cap
120898
Nozzle
120882
Electrode
120881
Swirl Ring
120880
PAC105 Torch
Unshielded Consumables
For CE compliance, do not use the unshielded consumables.